Ideal-Zanussi IZGS980ITX Bedienungsanleitung PDF herunterladen (Seite 4)

• You must have correct isolation devices:

line protecting cut-outs, fuses (screw

type fuses removed from the holder),

ground leakage trips and contactors.

Disposal of the appliance

• To prevent the risk of physical injury or

damage

– Disconnect the appliance from the

power supply.

– Cut off the mains cable where it con-

nects with the appliance and discard it.

– Flat the external gas pipes if there are

fitted.

– Speak to your local authorised facilities

for disposal of your appliance.

INSTALLATION

Warning! The following instructions

about installation, connection and

maintenance must be carried out by

qualified personnel in compliance with

standards and local regulations in

force.

Gas Connection

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not come

in touch with mobile parts or they are not

squeezed. Also be careful when the hob is

put together with an oven.

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values. The adjustable

connection is fixed to the comprehensive

ramp by means of a threaded nut G 1/2".

Screw the parts without force, adjust the

connection in the necessary direction and

tighten everything.

1

2

3

1 End of shaft with nut

2 Washer

3 Elbow

Flexible nonmetal pipes connection:

If it is possible to easily control the connec-

tion in its full area, you can use a flexible

pipe. Tightly attach the flexible pipe by

clamps.

Liquid gas: use the rubber pipe holder. Al-

ways engage the gasket. Then continue

with the gas connection. The flexible pipe is

prepared for apply when:

– it can not get hot more than room tem-

perature, higher than 30°C;

– it is no longer than 1500 mm;

– it shows no throttles;

– it is not subject to traction or torsion;

– it does not get in touch with cutting

edges or corners;

– it can be easily examined in order to

check its condition.

The control of preservation of the flexible

pipe consists in checking that:

– it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

– the material is not hardened, but shows

its correct elasticity;

– the fastening clamps are not rusted;

– expired term is not due.

If one or more defects are visible, do not re-

pair the pipe, but replace it.

Important! When installation is complete,

make sure that the seal of each pipe fitting

is correct. Use a soapy solution, not a

flame!

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the in-

jectors and replace them with the ones

which are necessary for the type of gas

4

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare