Ideal-Zanussi IZGS980ITX Bedienungsanleitung PDF herunterladen (Seite 5)

you use (see table in Technical Data

section).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating label (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this label in the package of the injectors

supplied with the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you

must fit an applicable pressure adjuster on

the gas supply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the control knob.

4. With a thin screwdriver, adjust the by-

pass screw position. If you change from

natural gas 20 mbar to liquid gas, fully

tighten the adjustment screw in. If you

change from liquid gas to natural gas 20

mbar, undo the by-pass screw approxi-

mately 1/4 of a turn (1/2 of a turn for Tri-

ple Crown burner).

1

1 Minimum adjustment screw

5. Make sure the flame does not go out

when you quickly turn the knob from the

maximum position to the minimum posi-

tion.

Electrical connection

• Ground the appliance according to safety

precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the lo-

cal power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a correct

plug, able to support the load marked on

the identification plate. The plug has to

be fitted in a correct socket.

• Any electrical component must be instal-

led or replaced by the Service Force

Centre technician or qualified service per-

sonnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the mains

plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple connection (risk of fire). Check

that the ground connection is in conform-

ity with the standard and regulations

force.

• The power cable must be placed in such

a way that it does not touch any hot part.

• Connect the appliance to the mains with

a device that lets to disconnect the appli-

ance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90 °C. The

blue neutral cable must be connected to

the terminal block label with "N". The

brown (or black) phase cable (fitted in the

terminal block contact marked with "L")

must always be connected to the live

phase.

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

5

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare